7 Best Rims for Tacoma in 2023【Designs & Guide】 - Truck Hunter (2023)

FAQs

What size wheels can I fit on my 2023 Tacoma? ›

Toyota Tacomas come stock with a range of rim sizes, including 16'' rims, 17'' rims and 18'' rims. And if your Tacoma is rocking a lift kit, you've got even more options. So, if you're wondering if you can put 17 inch rims on your Toyota Tacoma, the answer is a resounding yes.

The best ratio to re-gear, if you have the 4.0L to with 33s, would be 4:10 or 4:56. 4:10s would make the truck feel like it was on stock tires, and you'll get around 200 more RPMs at 70mph. 4:56 gears will definitely be more noticeable as you should see around a 300 RPM gain at 70mph.

What Is The Biggest Tire You Can Fit On A Stock Toyota Tacoma? We'll begin with the Tacoma's stock suspension here. The largest tire you can fit on a stock Tacoma without any rubbing or trimming will be a 265/75 on a 16-inch wheel, or a 265/70 on a 17-inch wheel.

The 33″ (285/70R17) tire size is a great tire size for the Tacoma because even if you don't have a lift kit or leveling kit, it takes very little effort to clear the fender well. If you add a suspension lift into the mix, and it gets even easier to clear this size tire.

The Civic Type R shows off 19-inch alloy wheels wrapped in super-sticky maximum-performance 265/30 ZR19 Michelin Pilot Sport 4S tires³³.

Typically, the best lift height on a Tacoma is 2-2.5 inches to keep your trucks other suspension components such as your stock upper control arms and cv axles from being too stressed. Usually going up to a 3inch lift will require aftermarket upper control arms to be aligned properly.

For flat places, a ratio of 2.6 to 3.0 is ideal for most people. The lower value of this range, with a cadence of 90 rpm, will allow us to ride around 30km/h, while the upper, 34km/h. If you're just starting out on your adventure on a single speed or fixed gear bike, a gear ratio of around 2.7-2.8 will be ideal.

If getting the best fuel economy is priority, then choose the lowest numerical number offered, such as 3.08, 3.23 or 3.31. This applies to highway driving; city driving mpg isn't really affected by the axle ratio.

Is it better to have a higher or lower gear ratio? A higher gear ratio is good when you need more acceleration to cruise your vehicle, whereas a lower gear ratio provides more torque to get the vehicle moving from a resting position.

In order to fit 35s, your Tacoma is going to have to be outfitted with aftermarket suspension. The minimum lift required will be 2 inches, with 3 inches being more ideal. You don't need to purchase an expensive setup to make these tires work. Any lift that gives you enough clearance will work here, even a spacer lift.

What size are stock Tacoma rims? ›

Every generation of Toyota Tacoma comes with a 6x139.

For sports cars, the general rule of thumb is to match the wheel width to the tread width in inches. For example a tire size 285/35-19 has a tread width of 9.9". The ideal wheel width would be 10.0" for that tire.

Yes, though there are some basic differences (which we will discuss later). They are largely similar in most parts. “285” points to the tread width in millimeters, while “33” denotes the tire's diameter in inches. In short, “285” indicates the metric sizes for 33” tires.

The simplest and most straightforward way of determining the width and diameter of the rim you'll need is by using the tire's size. As a general rule, the rim will have a width 1.5 inches smaller than your tire and the rim will be labeled to match the width and diameter of the appropriate tire.

“R” stands for the construction method of the tire indicating the tire is a radial tire. The following two numbers (16) indicate the diameter of the wheel rim in inches. The next two or three numbers (94) indicate the load index of the tire.

There are several heights to choose from, ranging from 1.5 to 6 inches. The height of your lift kit depends on your lifestyle and driving habits. If you are off-roading on uneven terrain, consider a kit closer to 6 inches that gives your vehicle higher ground clearance.

The two most important factors influencing your final choice are the model of your truck and the size of the rims. On average, if your truck isn't lifted, you can fit tires up to 33”. In case the vehicle is lifted, you can find a good set of 37” or larger tires to fit.

If you ride on really difficult terrain, this gives you the opportunity to upgrade to some more aggressive tires that can handle the rougher stuff easier. Going a little bigger with tires will also raise your ground clearance even more. The bottom line is that a 2″ lift will make a difference.

What is a 7 1 gear ratio good for? ›

7.1:1 to 9.0:1 – This has become the reel speed range we use most often. This reel gets used for Flippin', Froggin', deep jigs, swim jigs in warmer weather, soft plastic stickbaits, topwater and late season jerkbaits.

Towing: For pickup trucks released after 2010, the best axle ratio for towing falls somewhere between 3.55 and 3.73. This range provides good acceleration for V8 gas and diesel engines.

That's why I run a 4.56 gear ratio with 35″ tires. This gives me decent fuel efficiency at highway speeds, and enough low end power to throttle through difficult obstacles. Below I've outlined a gear ratio chart that cross compares tire size to gear ratio for the ideal RPM.

PERFORMANCE: The larger the axle ratio number, the quicker the truck will accelerate. For example, a truck equipped with 3.55:1 axle gearing will accelerate faster than one equipped with a 3.31 axle ratio. Similarly, a pickup with a 3.73 axle ratio will be faster than one with 3.55s.

If you don't want to stray out too far, a 46/17 to 42/17 are good gear ratios for smaller and occasional hills. These gear rates are considered a good middle ground that can be used in flat and hilly areas.

There are different cassette ratios. There are 11/25 and 12/25 for flat riding, while 11/28 or 11/30 cassettes are suitable for hilly courses and for some riders, suffice in the mountains. For most cyclists, however, the 11/32 and 11/34 cassettes are best suited for steep climbs.

A (numerically) lower gear ratio, such as 3.08:1, will provide better fuel economy but slower acceleration. It will also allow a vehicle to reach a higher top speed. On the other hand, a (numerically) higher gear ratio, such as 4.56:1, will offer faster acceleration but lower fuel efficiency.

According to Slesinski, Class 8 linehaul trucks that spend most of their time at highway cruising speeds usually fall into axle ratio ranges usually between 2.26 through 3.36:1 based on duty-cycle, speed, and type of transmission. Axle ratios for heavy-haul applications operating on-highway range from 3.08 to 4.10:1.

4.10s are going to accelerate faster and decelerate faster on lift. However the trade off is greater fuel consumption per mile driven and higher engine speed per given road speed. In basic terms the 4.10s will feel quicker and 3.73 will feel faster.

We mentioned before that the Toyota Tacoma can fit a nice amount of equipment inside its truck bed. In fact, it has a maximum payload capacity of 1,440 pounds.

How do I increase the load capacity of my Tacoma? ›

16-23 Tacoma 8.75" Nitro Gear & Axle Gear Package (4.88 Ratio)

As a general rule of thumb, it's safe to fit a tire up to 20 millimeters wider than stock on the original rim. The actual width of the tire will vary depending on the width of the rim: The tire will expand 5 millimeters for every half-inch (12.5 millimeters) increase in rim width.

You can put 16-inch, 17-inch, or 18-inch wheels on a Tacoma. The most popular size for Tacoma wheels is 17 inches. This size wheel offers the best balance of off-road and on-road performance.

What damages tires on my Toyota Tacoma? Some tires may last up to 50,000 - 60,000 miles, while others may last as microscopic as 10,000 miles. There are innumerable factors that affect the length of your tire's life. Everything from road conditions to tire usage may affect the life of your tires.

Stock tires won't be able to air down as much as an upgraded all-terrain or mud-terrain tire. I'd say a good rule of thumb for the stock wheel and tire set up on a 3rd Gen Tacoma is, don't drop below half of your normal of the regular street tire pressure.

33-inch tires work well with rims that measure 15 or 16 inches in width, while 35-inch tires should only be used with rims that are at least 17-inches wide.

For most standard tire sizes, the optimum rim width factor is between 0.8 and 0.9 of the tire section width for ideal performance and if the tire is used with lowest inflation pressure. For normal usage, tires work properly on rims from 0.7 to 0.95 of tire section width.

If a tire that's too wide for a rim is mounted, the tire shape becomes too tall and round, like a lollipop or lightbulb, and then it becomes floppy at the top because the casing is constricted. This can result in poor cornering performance and tire squirm.

Are wider rims better? ›

Wider rims support the tire better and allow for lower tire pressures. As rim and tire widths increase, rolling resistance (and wheel weight) consequently increases, but we've found 30mm-wide rims provide a nice compromise for most riders.

Wheel width is the distance, in inches, across the barrel of the wheel. Just like wheel diameter, rim width is measured from bead seat to bead seat, rather than from the rim flange. The width of the wheel in this example is 7 inches. The most common wheel widths vary from 6"-14".

For your safety, and for the optimal ride, your rim width and tire size must be compatible. Why? Because the rim width has a direct impact on your tire's contact patch, which changes how the tire interacts with the road and how your vehicle handles.

285 indicate 285/75/16, which is the metric size for 33 inches.

What size tire is 285/70R17 in Inches? The 285/70R17 tire has an overall diameter of 32.7 inches, a section width of 11.2 inches, and can be mounted on 17 x 7.5-9.0 inches rim.

A common Tacoma tire width for 3″ lift kits is 285mm. This means 17″ wheels, 285/70 R17's are a good choice (2″ taller and . 8″ wider than factory). For 16″ wheels, 285/75 R16's have similar dimensions as the 17″ wheels do.

The most common setup for this generation Tacoma on stock suspension is a set of 17x8. 5 0 rims with 265/70R17 tires. The lower offset rims and larger tires will help to give your truck a more aggressive look over your stock rims and tires.

Toyota Tacomas come stock with a range of rim sizes, including 16'' rims, 17'' rims and 18'' rims. And if your Tacoma is rocking a lift kit, you've got even more options. So, if you're wondering if you can put 17 inch rims on your Toyota Tacoma, the answer is a resounding yes.

Across its four available tire sizes, the Toyota Tacoma will come with either 16-inch, 17-inch, or 18-inch wheels.

Put simply, to find if your wheels will fit your car, measure the distance from your wheel's center point to where it is mounted. This is the offset. Add that to half your wheel's width to find the back space and subtract it to find the front space. Compare this to your wheel well to see if it fits.

What size are factory Tacoma wheels? ›

Every generation of Toyota Tacoma comes with a 6x139.

What Is The Wheel Offset On TRD Pro Wheels? The wheel offset on TRD Pro wheels is 4mm.

The offset of a wheel is the distance from its hub mounting surface to the centerline of the wheel. The offset can be one of three types (measured in millimeters).* "The offset of a wheel is the distance from its hub mounting surface to the centerline of the wheel."

To increase performance, your tire should be compatible with your rim size. 33-inch tires work well with rims that measure 15 or 16 inches in width, while 35-inch tires should only be used with rims that are at least 17-inches wide.

it's unusual, but you can do it. you need to use taller tires to keep the overall diameter the same. and you need to make sure the new tires have the same speed rating or higher than the factory ones.

Width and diameter are the two factors that determine tire and rim compatibility. For diameter you'll need to be sure that your tires and wheels are an exact match, e.g. a 215/65R17 tire will only fit on a 17" diameter wheel. There's a bit more flexibility when it comes to wheel widths.